See the tricks and tricks" series: engraving machine empty moments

    The engraving machine, like people, will get tired and get sick. When a person is sick and takes medicine, he can return to normal. If the engraving machine fails, only parts or repairs can be replaced, and a small amount of expenses must be paid. Therefore, daily maintenance and troubleshooting are particularly important. Today we are dedicated to explaining the reasons and solutions for the engraving machine.

Cause (1): The ammeter is damaged and the current is out of control.
"See tricks and tricks" coup: wear safety and protection equipment, check the current meter for damage, if the damage, please immediately power off, replace the new electricity

Flow table.

Cause (2): The circuit or circuit is damaged, resulting in power failure or short circuit.
"See the tricks and tricks" coup: If the equipment emits charred odor, timely power off and replace the new board and circuit.

Cause (3): The laser tube is aging or damaged and cannot work normally.
"See the tricks and tricks" coup: Laser tubes have a certain service life, please replace them in time after the deadline.

Reason (4): The laser light path is offset, and it is impossible to indicate the work at the specified position, resulting in an empty cut.
"See the tricks and tricks" coup: strictly adjust the laser light path according to the instructions.

Cause (5): The laser power supply is damaged, causing the laser to fail to work.
"See the tricks" trick: replace the appropriate power supply to ensure normal work.

    The above is only a rough reference to 5 related faults. I hope you will point out the incompleteness. Or if you have some details, please feel free to contact our technical staff, who will patiently answer your questions.